5
1.
2.
3.
4.
5.
6.
Remove the four bolts that secure the safe to the skids using a wrench or
11/16” (17mm) socket.
With a person stabilizing the safe, carefully tilt the safe to the left and pull the
shipping skid on the right side away from the bottom of the safe.
With the shipping skid removed from one side of the safe, carefully lower the safe
to the floor. Follow the same procedure to remove the remaining shipping skid.
Open your safe door and locate and remove the four black caps on the
safe floor. This will provide access to the factory drilled bolt down holes.
To secure your safe to the floor it will first be necessary to drill pilot holes
in the floor surface.
Drill the appropriate diameter and depth of pilot holes based on the type of
hardware being used and the type of floor surface. For the hardware provided
(concrete floor installation) we recommend using a hammer drill and 1/2”
concrete drill bit to drill holes the four corresponding in the concrete floor.
Insert and drive the plastic anchoring plugs into the pilot holes. You may need
to use a hammer to fully insert the plugs into the pilot holes.
Secure the safe, by threading all 4 anchor bolts through the factory drilled bolt
down holes in the bottom of the safe and ratcheting down tight.
8. Replace the four black caps onto the floor of the safe.
7.
Make sure the metal washer sits on top of the rubber washer. Tighten the bolt
to compress the rubber washer between the safe and metal washer. Failure to
do so will allow water to enter the safe in the event of a flood.
9. SKID REMOVAL AND SECURING
17mm
BOLT
17mm
BOLT
• DRILL / HAMMER DRILL
• DRILL BIT – 1/2” (For installing into
concrete with provided hardware)
• WRENCH / 11/16” (17mm) SOCKET
• HAMMER
FASTENING HARDWARE
TOOLS FOR SKID REMOVAL & SECURING
BOLT
ANCHOR
FENDOR
WASHER
FLOOR
WARNING: A second person must hold and stabilize the safe to keep it from tipping,
causing injury, and/or damage to the safe and surrounding structures. Make sure the
door is closed and locked while removing the skids. Failure to do so will compromise
the safety, security, and warranty of the safe. Use the hardware provided or consult
your hardware retailer for skid removal and fastening to mounting surface.
