12
1-800-732-0144
Program the Collar Receiver for
Two-Dog Operation
SportDOG Collar Receivers can be set to respond to either the up or down toggle
switch position. A SportDOG Add-A-Dog
®
receiver must be purchased to train a
second dog in two-dog mode.
1.
Program the Remote Transmitter to mode 2, 3, 4, 6 or 8 (see
page 10-11).
2.
Flip the toggle switch to the
up
position to program the fi rst
Collar Receiver.
A.
Turn the Collar Receiver off.
B.
Press and hold the On/Off Button. The Receiver Indicator
Light will come on, then turn off in 4-5 seconds. If the
On/Off Button is released too early, the Receiver Indicator
Light will begin its normal fl ashing. If this occurs, start over
and repeat from
A
.
C.
After the Receiver Indicator Light has turned off, release the
On/Off Button.
D.
Press and hold the Orange Button on the Remote
Transmitter until the Receiver Indicator Light fl ashes 5
times.
Note: In mode 6, press and release the Orange Button
repetitively until the Receiver Indicator Light fl ashes 5 times.
You
may need to hold both units 2-3 feet from each other. If the
Receiver Indicator Light does not fl ash 5 times, start over
and repeat from
A
.
3.
Program the second Collar Receiver the same way using
A.
Toggle set to
up
position
for Dog 1 or
Toggle set to
down
position
for Dog 2
through
D.
above, but with the toggle switch in the
down
position.
___________________________________________________________
Program the Collar Receiver for
Three or Six-Dog Operation
A SportDOG Add-A-Dog
®
receiver must be purchased to train additional dogs.
1.
Program the Remote Transmitter to Mode 5 or 7.
2.
Flip the toggle switch to the
up
position.
3.
Program the fi rst Collar Receiver:
A.
Turn the Collar Receiver off.
B.
Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator
Light will begin its normal fl ashing. If this occurs, start over and repeat the process.
C.
After the Receiver Indicator Light has turned off, release the On/Off Button.
D.
Press and hold the Orange Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 2-3 feet from each other.
If the Receiver Indicator Light does not fl ash 5 times, start over and repeat the process.
4.
Program the second Collar Receiver using
A.
through
D.
above, but using the
Middle
Button
in place of the Orange Button.
5.
Program the third Collar Receiver using
A.
through
D.
above, but using the
Lower Button
in place of the Middle Button.
6. If you want to add a fourth, fi fth or sixth collar, repeat the above steps with the toggle switch
in the
down
position.
Step
8
Step
7
