SPORTDOG.COM 15
14 1-800-732-0144
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a specific installation. If interference does occur to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
• Contact customer service or an experienced radio/TV technician for assistance
Unauthorized changes or modifications to the equipment may violate FCC regulations and could void the user’s
authority to operate the equipment.
BATTERY DISPOSAL
WARNING
CAUTION
NOTICE
See Important Safety Information on page 2 related to the battery.
Separate collection of spent batteries is required in many regions; check the regulations in your area before
discarding spent batteries. If you wish to ship us your spent batteries for disposal, contact the Customer Care Center.
This device operates on one (1) 3.7V, 160mAh Lithium-ion battery; replace only with equivalent battery.
At end of product life, use these battery removal instructions for final disposal:
• Using a 3/32 hex driver, remove the two case screws.
• Remove the case back or cover.
• Remove the old battery pack.
WARNING
CAUTION
NOTICE
• When removing the old battery pack, care must be taken when gripping the connector firmly to avoid damaging
the wires. Shorting the battery wires may cause fire or explosion.
• These instructions are not valid for repair or battery replacement. Replacing the battery with a battery not
specifically approved by Radio Systems Corporation may cause fire or explosion. Please call the Customer Care
Center at 1-800-732-0144 to avoid invalidating your warranty.
For a list of patents protecting this product, please visit:
http://www.radiosystemscorporation.com/patents
