5
Communication Cable Requirements (for cable-controlled systems only):
Four conductor cable – 28 gauge, twisted pair (two pairs), shielded data cable
MOUNTING THE SCOREBOARD TO A WALL
NOTE:
Use hardware appropriate for the wall type you are mounting to and capable of
supporting the weight of the scoreboard. No mounting brackets are necessary as the pre-
drilled mounting flanges on the top and bottom of the scoreboard are provided to mount the
scoreboard directly to the wall. The scoreboard must be attached to the wall securely through
all four (4) mounting holes in the top and bottom mounting flanges. (See the figure below for
location of mounting holes and mounting flanges.)
1. Remove the scoreboard from its packaging, making sure not to pry against or cut into the
scoreboard. Inspect the unit for shipping damage according to the instructions on page 3.
2. Connect a lift device to the two hanging brackets on the top of the scoreboard and lift the
scoreboard into place. Cardboard or foam packaging can be used as a pad between the lift
and scoreboard to protect the face of the scoreboard. Remove the antenna from the
scoreboard if your system is wireless. (See the figure below for location of hanging brackets.)
3. Lift the scoreboard to the desired location and mark the holes in the top and bottom flanges. It
may be necessary to mark the top flange, install anchors, and secure the top of the scoreboard
before having access to the bottom flange. Ensure that you use all four (4) mounting holes in
the top and bottom flanges.
4. Replace the antenna if your system is wireless.
