Spokey AURIS, Manual

Page: 19 / 54

19
www.spokey.eu
www.spokey.pl
SAFETY KEY
A safety key is intended to deactivate the treadmill immediately if you fall
down. It serves as an emergency stop. The safety key must be used in
urgent cases only.
For safe and convenient stop, use START/STOP button until the treadmill
stops completely. Once you have pressed START/STOP, the treadmill belt
will gradually decreased its speed. The treadmill will not activate until you have inserted the safety key in the key hole located in the centre of the
counter control desk, which provides additional protection to treadmill
activation by third parties. The other end of the key must be attached to
clothes. If you fall down, the safety key will fall out the control desk and the
treadmill will stop immediately. Use only in urgent situations
ACTIVATION
Connect the plug to the socket, the counter display turns on and the track
goes into standby mode.
SLEEP MODE
After 10 minutes of inactivity, the track goes into sleep mode and the
counter is turned off. Press any button to resume the track.
BUTTON FUNCTIONS
START/STOP press to start the training or a chosen programme. 3
seconds after the start, the running belt will start moving at the lowest
possible speed or at the speed corresponding to a chosen programme.
Press to stop the training. The treadmill will be slowing down until it stops
completely.
SPEED +/- - in sleep mode used to set values. While in operation, pressing
the buttons increases / decreases the speed by 0.1 km/h. Pressing the
button for more than 5 seconds will make the value increase/decrease in
continuous mode.
I/- - in sleep mode used to set values. While in operation, pressing
the buttons increases/decreases the inclination angle by 1 level. Pressing
the button for more than 5 seconds will make the value increase/decrease
in continuous mode.
DISPLAY INFORMATION
SPEED: current speed.
TIME : workout time.
Incline: inclination angle of the treadmill belt during workout. .
MEASUREMENT RANGE
Speed
– adjustable between 0 and 16 km
QUICK START (MANUAL MODE)
In the manual mode you can set the speed while running by pressing the
speed adjustment buttons (SPEED). The training starts 3 seconds after pressing START button and stops after
pressing STOP button.
TROUBLESHOOTING
Error or error code Reason Solution
Display not show A. no power Connect the power
B. power switch not on Turn on power switch
C. pcb no power Press over-load key or change new pcb
D. computer wire broken Change new wire
E. computer broken Change new computer
F. back ground light not on Check the wire or change new
Display not complete A. display IC not well welded Re-welded it.
B. conductive bar not well fixed Re-fix it.
C. display IC broken Change new IC.
Running belt not smooth,shaking A. motor has resistance Adjust motor or add some lubricate oil.
B. motor belt too tight Adjust motor belt
C. pcb torque too small or too big Adjust pcb torque to suitable position
Display show” ---“ E00/E07
A. no safety key Put safety key
B. magnetron not well fixed Fix it well.
E01/E13 A. signal wire not well connect Re-connect it
B. signal wire broken Change new one
C. computer wire broken Change new computer
D. pcb signal wire broken Change new pcb
E02 A. motor wire not well connected Re-connect it
B. IGBT broken on pcb Change new pcb
C. input voltage too low Stop using and ask electrician to repair.
E04 A. incline motor wire not well connected Re-connect it.
B. incline motor broken Change new one
COUNTER