6 |
EN | instruction
8. FOLD AND UNFOLD
Take off the covers on the handle bar,then take
off the M8*40 screws and Pads,folded the com-
puter;Loose the knobs at the bottom of the fra-
me,folded the support frame,make the support
frame computer and the base of the frame in flat
position,then tighten the knob to lie the machi-
ne against the wall.Please not:KEEP CHIILDREN
AWAY to avoid the machine fall down.
9. USAGE OF SILICONE OIL
Pull up tightly of the running belt. Then put
the silicone oil to running board. Then start the
machine to running 3 minutes without loading.
It is better to maintain like this every 30 hours
working of the machine. This can save lifetime of
parts properly.
1. Running belt deviate to left
Start the machine by speed at 5-6km/h without
loading, use die nut to make the screw go 1/4
circle(see fig1). Then make the machine running
without loading 1-2 minutes. Please adjust like
this to make the belt till to mid place.
2. Running belt deviate to right
Start the machine by speed at 5-6km/h without
loading, use die nut to make the screw go 1/4
circle(see fig2). Then make the machine running
without loading 1-2 minutes. Please adjust like
this to make the belt till to mid place.
3. Running belt logjam
If the running belt is in dead condition, use die
nut to make the screw 1/2 circle both left and
right till this logjam solved.
10. RUNBELT ADJUSTION
11. DAILY MAINTAINANCE
1. Please disconnect power before checking the
machine or cleaning.
2. Clear belt and dial plate after use, at least once
a week.
3. Check and tighten screws and spines at fixing
point.
Summary of Contents for 928648
Page 2: ...2 B A ...
