85
Spohn & Burkhardt
DRAFT
Adjust the position of the monitor with the monitor arm (
9.2
) as follows:
The monitor rotation and tilt can be adjusted continuously by moving the monitor to the required po-
sition.
7. Servicing
Danger!
All tasks on the device are only allowed to be undertaken by specialist personnel taking
into account the relevant safety regulations. Always pay attention to the safety instruc-
tions in
7.1. Control stand
Servicing measure
Interval
Function test
before starting work
Visual inspection/cleaning
regularly
Check screw joints
after the first 200 hours of operation,
every 6 months thereafter
Lubricate pivoting motor base
every 6 month
Check friction wheel contact force
after the first 200 hours of operation,
every 6 months thereafter
7.1.1. Visual inspection
Danger!
Transport the control stand using suitable hoisting equipment. During transport, pay at-
tention to loose parts of the control stand.
1. Check the entire control stand and its components for soiling.
• If necessary, remove any soiling.
2. Check the control stand and its components for damage:
• Take damaged control stands out of operation.
• Replace damaged components,
(see chapter 8. “Repair”, page 87).
7.1.2. Function test
Danger!
Damaged control stands are not allowed to be operated.
1. Check the adjusting functions of the control stand FS as per
chapter 6. “Operation”, page 71.
• If you are not able to operate one of the adjusting functions, take the control stand
out of operation and contact
SPOHN & BURKHARDT
(
for address
2. Check the functions of the control stand FS as per the requirements of the operating organization.
Summary of Contents for FS Series
