BANTAM
– OPERATIONAL INSTRUCTIONS
PAGE 3
WWW.4X4sPOD.COM
JUMPER ON 2 PINS ON RIGHT
FOR POSITIVE TRIGGER
JUMPER ON 2 PINS ON LEFT
FOR GROUND TRIGGER
-L
O
W
V
O
L
T
A
G
E
B
Y
P
A
S
S
-L
O
C
K
-O
U
T
1
2
/2
4
V
P
O
W
E
R
IN
P
U
T
-IN
P
U
T
F
O
R
S
W
IT
C
H
#
1
-IN
P
U
T
F
O
R
S
W
IT
C
H
#
2
-IN
P
U
T
F
O
R
S
W
IT
C
H
#
4
-IN
P
U
T
F
O
R
S
W
IT
C
H
#
3
-IN
P
U
T
F
OR
S
W
IT
C
H
#
8
-IN
P
U
T
F
O
R
S
W
IT
C
H
#
6
-IN
P
U
T
F
O
R
S
W
IT
C
H
#
7
-IN
P
U
T
F
O
R
S
W
IT
C
H
#
5
JUMPER LOCATION
INPUT 1:
Use this input to disable the low voltage cut off by attaching 12/24v from a positive power feed. This will override the LVCO.
INPUT 2:
Use this input to activate the Key-On/Lock-Out function from a source of 12v/24v from a positive power feed, such as a fuse
or circuit that is live when the ignition key is on. (NOTE) ALWAYS attach to input first, then attach to the power last to avoid a short.
INPUTS 3-10:
Use these inputs to activate any of the switches (outputs 1-8) by an external device that has a 3.3
– 24VDC signal.
EXAMPLE: Outputs can be controlled by external devices such as, but not limited to:
Thermostats, Alarm systems, Sending units, Sensors, Limit switches, Pressure switches, Remote switches,
Arduino, Raspberry Pi and many more devices that utilize ground or positive triggers ranging from 3.3VDC
– 24VDC
JUMPER:
Use this jumper to switch the 8 inputs between Positive trigger input and Ground trigger input. (NOTE: this applies to all 8 inputs)
INPUT TERMINAL BLOCK
JUMPER FOR +/- INPUT TRIGGERS
!!! CAUTION !!!
ALWAYS ATTACH TO INPUT TERMINAL
BLOCK FIRST, THEN ATTACH POWER SIDE
