Page 5
Assembly Instructions
Assemble the Tow Bar – (See Figure 1.)
1. Remove the front strapping from the log splitter,
but leave the log splitter on the pallet.
2. Insert the front stand into the tow bar and install
the pin through the second hole in the front stand.
3. Slide the tow bar into the receiver tube. Install the
pins through the first set of holes in the tow bar.
4. Install a 5/16" x 2-1/2" hex bolt and 5/16" nut in the
end hole of the tow bar as a safety catch.
5. Remove the log splitter from the pallet.
Assemble the Tray – (See Figure 2.)
1. Slide the tongue in about half way for clearance.
2. From the front of the log splitter, slide the tray onto
the bottom flange of the I-beam. Align the holes in
the tray and the I-beam and install six 3/8" x 1-1/2"
hex bolts and flat washers down into the holes.
Assemble 3/8" lock washers and 3/8" nuts onto the
bolts and secure the tray to the I-beam.
Position the Tow Bar
1. Pull the tow bar out to the towing position, or push
it in to the working position. Align the holes in the
tow bar and the receiver tube and install the two
locking pins and hair cotter pins.
Install the Bail Pin
1. Install the bail pin in the trailer hitch coupler.
Hardware Package Contents
Locking Pin
48978 (2 pcs.)
Hairpin Cotter
714-0117 (2 pcs.)
5/16” x 2-1/2” Hex Bolt
44292 (1 pc.)
3/8” x 1-1/2” Hex Bolt
43062 (6 pcs.)
3/8” Hex Nut
HA21362 (6 pcs.)
5/16” Hex Nut
47810 (1 pc.)
3/8” Washer
43081 (6 pcs.)
3/8” Lock Washer
43003 (6 pcs.)
Locating Pin
HA5236 (1 pc.)
Hairpin Cotter
43343 (1 pc.)
48515
Bail Pin
FIguRe 2
3/8” x 1-1/2” HEX BOLT
3/8” NUT
3/8” LOCK WASHER
3/8” FLAT WASHER
FIguRe 1
5/16” x 2-1/2” HEX BOLT
5/16” NUT
LOCKING PIN
HAIR COTTER PIN
RECEIVER TUBE
HAIR COTTER PIN
LOCATING PIN
