Installation and Reference Manual
System Operation
Installation and Reference Manual v3.2/0410/6
59
Installing the PCS 60 software on a Windows PC
1
The set up file will be supplied in a compressed folder called, for example, PCS60.3.2.31.msi.zip.
Open this folder.
2
Run (double click) the set up file called, for example, PCS60.3.2.31.msi
3
At the Welcome screen select Next to continue the
installation
4
By default the software will be loaded into C:\Program
Files\SpliceCom\PCS60. Change this location if required.
5
Where relevant you will also have the option to load the
software for all Users of the PC or just for the currently
logged in User.
6
Select Next when ready
7
At the Confirm Installation screen select Next.
8
The software will be installed
9
At the Installation Complete screen select Close
PCS 60 as an IP Soft Phone on a Windows PC
The PCS 60 software can be run as an IP soft phone where the PC becomes the User’s telephone and the
voice path will be via the PC. Therefore the PC will require a headset, microphone, sound card etc
installed.
Before starting:
1
The PC must have a network connection to a Call Server.
2
An IPUser licence must be previously installed and be available. (For further details please refer to
page 35.)
Running the PCS 60:
1
Run the PCS60.exe file either from the Installation folder, eg C:\Program Files\SpliceCom\PCS60, or
create a short cut to this file in the required location and double click on the short cut.
2
The PCS 60 application will open.
3
The “Searching for Server” message will be displayed as the registration process on the Call Server
is started.
If the “Searching for Server” message remains and the PCS 60 does not continue to the next step
check that the PC can communicate with the Call Server or refer to the Connect to the Call
Server Remotely section below.
4
The “No Licences Available” message will be displayed while the phone is registered as described
in step 5.
5
If the Auto Add Phones feature is turned on the Call Server will automatically register the PCS 60.
(Please refer to page 34 for further details.)
If the Auto Add Phones feature is turned off:
a
In Manager select Unassigned Phones
b
The hardware address of the PC will identify the PCS 60 to be connected. Click on the entry
required. (If the PCS 60 is not listed check the installation of the IPUser licence as detailed
from page 35.)
c
From the Status list box select Member
d
Select Update when ready