5. If you don't see a T.A. device in step 3, then you need to go to Control Panel-> Device Manager and find
the Serial USB Port. You may have to unplug/disable other USB devices until you can assign it to a Port
that the Memory Manager can communicate with (COM1-COM6) using the Properties -> Port Settings ->
Advanced -> COM Port Number.
6. Run Memory Manager -> Setup -> TEST COM, and you should get a T.A. status on the port you assigned in step
5.
7. Select the corresponding COM Port and click SAVE.
8.
If you are processing several Bootloaders and are certain you are plugging the Bootloader into the same
USB port each time, leave the same COM port selected.
9. In Memory Manager -> Configure Bootloader, set the IP address of your Bootloader to the required IP address
10. Set the Subnet-Mask to 255.255.255.0 unless otherwise required.
11. Each Bootloader on the same network must have a unique BLD Number, so we suggest you set the BLD
Number to the same as the last octet of the IP address. Ie, for IP address 192.168.66.210 set the BLD Number to
210
12. The Gateway is not used so set it to 0.0.0.0, HTTP Port is always 80 and TA Port is not used so leave it at 40000.
13. Click OK, then Save.