SPL StreetBop S5418SMG, Assembly Manual

Page: 4 / 8

Velocity Series Drum Set Owner’s Manual
4
1.
Place smooth white resonant side bass drum head with the SPL
logo on front of the bass drum shell.
2.
Place bass drum hoop onto drum head.
3.
Insert long tension rod / washer / bass drum claw hook assembly
into bass drum lug. Make sure claw hook is secure on the bass
drum hoop. Tighten with your fingers.
4.
Repeat this for all the lugs on one side of the drum.
5.
After all tension rods on one side are finger tight, use the drum key
to tighten the #1 tension rod 3 turns. Follow these steps for tension
rods #2 through #8 in a criss-cross pattern as shown. Repeat this
pattern, tightening each rod one half turn until the drum head is
taut and wrinkle free.
6.
Repeat for the coated white batter head on the player’s side of
the drum.
Bass Drum Head Assembly
Washer
Bass Drum Hoop
Bass Drum Claw
Long Tension Rod
Shell
Bass Drum Lug
1
2
3
4
5
6
7
8
FRONT - Audience Side
Bass Drum Leg Assembly (Spurs)
1.
Loosen wing nut on spur assembly.
2.
Rotate the bass drum spur down and forward.
3.
Tighten the bass drum spur into the forward position.
Wing Nut
Spur Assembly
Assembly Instructions:
S5418SMG