S o u n d P e r c u s s i o n L a b s . c o m
Mounted Tom Assembly - to Bass Drum
Support Collar 2
Support
Collar 1
Support Collar 2
Thumb screw on
bass drum mount
(top view)
1.
Set desired height of the support arm
(G)
using
thumb screws on bass drum mount (located on top
of bass drum).
2.
Loosen Support Collar 1 using drum key. Then, slide
support arm down to fit into bass drum mount.
Make sure to align collar nub into indentation on
mounting base.
3.
Set angle of support arm to desired angle
& tighten thumb screw.
4.
Using drum key, loosen Support Collar 2.
5.
Slide mounted tom drum
(B)
onto support arm &
tighten Support Collar 2. The mounted tom drum
should be located to the left when drumming.
Snare Drum Stand Assembly
Snare Arms
(basket)
Tilter
Assembly
Height
Adjustment
Insert Wingnut
Hi-Hat Cymbal Stand Assembly
1.
Extend legs of Hi-Hat Stand
(I)
into
open position and tighten set screw.
2.
Place center arm of pedal at stand
base and insert bolt through bottom
opening. Secure with washer and
wingnut
(V)
on top.
3.
Slide upper tube over inner rod of
leg assembly and tighten set screw.
4.
Place one Hi-Hat cymbal
(L)
onto
seat as shown.
5.
Attach 2nd Hi-Hat cymbal
(L)
to
clutch assembly by placing cymbal
between felts of Hi-Hat clutch.
6.
Slide clutch assembly (set screw
at top) cymbal onto Hi-Hat rod
and tighten set screw. Position top
cymbal about ½" from bottom.
7.
Finished Hi-Hat cymbal stand should
look like this. When pedal is pressed
down with foot, the top cymbal will
be brought down to closed position.
Upper Tube
Inner Rod
Hi-Hat Clutch
Hi-Hat
Cymbal Seat
1
2
3
4
5
6
7
1.
Extend legs of snare drum stand
(H)
into
open position. Adjust down to top of line indication
mark at leg base. This will ensure maximum stability
for the snare drum stand.
2.
Insert wingnut
(U)
into middle snare arm.
3.
Adjust the basket to the angle shown with the
tilter assembly.
4.
Place snare drum
(C)
in snare basket. For best
playability, position top adjustment angle of
snare stand so snare drum playing surface sits flat.
Increasing angle of adjustment can cause snare
drum and stand to fall over and may cause injury.
Position the arms to fit snug to the drum.
Leg Adjustment
Line Indication Mark
10182 SPL D1316 Li'l Kicker Assembly Manual.indd 3
6/5/14 4:52 PM
