32
Maintenance:
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
1) The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the bolts
sufficiently. I cannot stress this point enough; 90% of calls to the service department for
noise issues can be traced to loose hardware.
2) The crank arm nut and/or the pedals need to be retightened.
3. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling
pads on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust
the levelers.
Maintenance Menu in console software:
The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance menu (may be called Engineering mode, depending
on version) press and hold down the Start, Stop and Enter keys. Keep holding the keys down for
about 5 seconds and the message window will display “ALTXXXX Engineering mode”. Press the
enter button to access the menu below:
a.
Key test
(will allow you to test all the keys to make sure they are functioning)
b.
Display test (
tests all the display functions)
c.
Functions
(Press enter to access settings)
i.
Sleep mode
(Turn on to have the console power down automatically after
20 minutes of inactivity)
ii.
Pause Mode
(Turn on allow 5 minutes of pause, turn off to have the console
pause indefinitely)
iii.
ODO reset
(reset the odometer)
iv.
Units
(Set to English or Metric display readings)
v.
Beep
(Turn on or off the beep when a key is pressed)
vi.
D/A test
(tests the brake resistance)
vii.
Exit
d. Security
(Allows you to lock the keypad so no unauthorized use is allowed)
e. Factory settings
(Access only allowed by manufacturing)
Summary of Contents for CR800
Page 7: ...6 Tools 114 Phillips Screw Driver 1 pc 112 12 14mm Wrench 1 pc 132 14 15mm Wrench 1 pc ...
Page 13: ...12 Tools 93 Phillips Screw Driver 1pc 100 12 14mm Wrench 1pc 117 13 15mm Wrench 1pc ...
Page 34: ...33 Recumbent Exploded View Diagram ...
