22
General Maintenance
1.
Wipe down all areas in the sweat path with a damp cloth after each workout.
2.
If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two reasons:
I.
The hardware was not sufficiently tightened during assembly. All bolts that were installed during
assembly need to be tightened as much as possible. It may be necessary to use a larger wrench than
the one provided if you cannot tighten the bolts sufficiently. I cannot stress this point enough; 90%
of calls to the service department for noise issues can be traced to loose hardware.
II.
The crank arm nut needs to be retightened
III.
If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling pads
on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
Engineering Mode Menu
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key
is pressed for example. To enter the Engineering Mode Menu, press and hold down the
Start
,
Stop
and
Enter
keys. Keep holding the keys down for about 5 seconds and the Message
Center will display Engineering Mode Menu. Press the
Enter
button to access the menu below:
a.
Key Test (Will allow you to test all the keys to make sure they are functioning)
b.
LCD Test (Tests all the display functions)
c.
Functions (Press
Enter
to access settings and
+
arrow to scroll)
i.
Sleep Mode (Turn on to have the console power down automatically after 20 minutes of inactivity)
ii.
Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)
iii.
ODO Reset (Resets the odometer)
iv.
Units (Sets the display to readout in English or Metric display measurements)
v.
Beep (Turns off the speaker so no beeping sound is heard)
vi.
Motor test (Continually runs the tensioning gear motor)
vii.
Safety
d.
Security (Allows the keypad to be locked to prevent unauthorized use)
Summary of Contents for 161168355
Page 23: ...23 Exploded View Diagram...
