CUSTOMER SERVICE 1-888-707-1880
EMAIL:
Dyaco Canada Inc. 2013
29
Before contacting your dealer for aid, please review the following information. It may save you
both time and expense. This list includes common problems that may not be covered under the
treadmill’s warranty.
PROBLEM SOLUTION/CAUSE
Display does not light
1) Tether cord not in position.
2) Circuit breaker on front grill tripped. Push circuit breaker in
until it locks.
3) Plug is disconnected. Make sure plug is firmly pushed into
230 VAC wall outlet.
4) Breaker panel circuit breaker may be tripped.
5) Treadmill defect. Contact your SPIRIT dealer.
Tread-belt does not stay centered
The user may be walking while favoring or putting more weight
on either the left or right foot. If this walking pattern is natural,
track the belt slightly off-center to the side opposite from the belt
movement.
Treadmill belt hesitates when walked/run on
See General Maintenance section on Tread-belt Tension.
Motor drive belt may be loose.
Motor is not responsive after pressing start
1) If the belt moves, but stops after a short time and the
display shows “LS”, run calibration (See procedure on
next page).
2) If you press start and the belt
never
moves, then the
display shows LS, contact service.
Treadmill will only achieve approximately
7 kph but shows higher speed on display
This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an extension
cord. If an extension cord is required it should be as short as
possible and heavy duty 16 gauge minimum. Low household
voltage. Contact an electrician or your SPIRIT dealer. A
minimum of110 volt AC current is required.
Tread-belt stops quickly/suddenly when
High belt/deck friction.
tether cord is pulled
Treadmill trips on board
15
amp circuit
High belt/deck friction.
Computer shuts off when console is
touched (on a cold day) while walking/running
Treadmill may not be grounded. Static electricity is “crashing”
the computer. Refer to Grounding Instructions on page
3
.
House circuit breaker trips, but not the
Need to replace the house breaker with a “High
treadmill circuit breaker.
inrush current” type breaker (see page
3
for details)
Service Checklist - Diagnosis Guide
