+1 800-SPIRENT – www.spirent.com
Spirent Setup Guide:
Information subject to change.
71-007894.A8
Vertex Channel Emulator
Page 5 of 6
Applying Power to the System
1 Make sure the loopback cable is connected on the rear panel of the Vertex instrument.
2 Connect the AC power cord to the power connector on the rear panel of the Vertex instrument.
3 Plug the power cord directly into the wall outlet on an individual branch circuit.
4 Press the power switch on the rear panel of the Vertex instrument.
5 Press the power switch on the front panel of the Vertex instrument.
The LED above the power switch changes from solid
orange
to blinking
green
. Blinking
green
indicates
that the instrument is booting up.
After the instrument boots up, the LED changes to solid
green
.
6 Repeat Steps 1 through 5 for each Vertex instrument.
Power Connection Procedure
Instructions
Perform the following steps after you have completed all cable
routing on the rear panel and the front panel.
NOTE
:
If the AC power voltage is <200V, make sure to connect a 20A power cord
to Vertex.
20A Receptacle
