Spirax Sarco 0722195, Installation And Maintenance Instructions Manual

Page: 3 / 20

IM-S03-11 CMGT Issue 5
3
HM and HM34 Inverted Bucket Steam Traps
Safe operation of this product can only be guaranteed if it is properly installed, commissioned,
used and maintained by qualified personnel (see Section 1.11 ) in compliance with the operating
instructions. General installation and safety instructions for pipeline and plant construction, as
well as the proper use of tools and safety equipment must also be complied with.
1.1 Intended use
Referring to the Installation and Maintenance Instructions, name-plate and Technical Information
Sheet, check that the product is suitable for the intended use / application.
The product listed below complies with the requirements of the Pressure Equipment Directive
2014/68/EU and carries the
mark when so required.
The product falls within the following Pressure Equipment Directive categories:
Product
Group 2
Gases
Group 2
Liquids
HM and HM34 SEP SEP
i) The product has been specifically designed for use on steam, air or water /condensate which
are in Group 2 of the above mentioned Pressure Equipment Directive. The products’ use on
other fluids may be possible but, if this is contemplated, Spirax Sarco should be contacted to
confirm the suitability of the product for the application being considered.
ii) Check material suitability, pressure and temperature and their maximum and minimum values.
If the maximum operating limits of the product are lower than those of the system in which it
is being fitted, or if malfunction of the product could result in a dangerous overpressure or
overtemperature occurrence, ensure a safety device is included in the system to prevent such
over-limit situations.
iii) Determine the correct installation situation and direction of fluid flow.
iv) Spirax Sarco products are not intended to withstand external stresses that may be induced by
any system to which they are fitted. It is the responsibility of the installer to consider these
stresses and take adequate precautions to minimise them.
v) Remove protection covers from all connections before installation.
1.2 Access
Ensure safe access and if necessary a safe working platform (suitably guarded) before attempting
to work on the product. Arrange suitable lifting gear if required.
1.3 Lighting
Ensure adequate lighting, particularly where detailed or intricate work is required.
1.4 Hazardous liquids or gases in the pipeline
Consider what is in the pipeline or what may have been in the pipeline at some previous time.
Consider: flammable materials, substances hazardous to health, extremes of temperature.
1. Safety information