10
INSTALLATION
Fixing
There are several fixing screw positions, located in the vertical side trims as follows:
(A) – top of grill opening
(B) – bottom of grill opening
(C) – middle of oven opening.
Only 4 fixing screws are required to fix cooker securely, 2 per side. Make sure the cooker is
fully home in the cabinet/aperture. Open the oven door and use position (C) on the none
hinged side. Open the grill door and use Position (A) on the same side the oven fixing was
put in, and Positions (A) and (B) on the other side of the grill opening. Screw into place using
a flange head Nº 6 woodscrew.
Utensil Rail And Hooks (optional)
The utensil rail is designed to be fitted onto the optional glass splashback. If the hooks are
not already on the rail, they need to be added prior to fitting. The two pillars on the utensil rail
will unscrew using a large flat head screwdriver, only one need be removed to add the hooks.
Slide the hooks onto the rail with the hook point away from the pillars. Screw on the pillar and
fit the utensil rail to the splashback. With the hooks hang downwards and pointing away from
the glass, fit using M4x12 pozi pan-head screws and 2 plastic washers per fixing. The
washers must sandwich the glass from the utensil rail and screw.
Glass Splashback (optional)
The splashback must have a support batton (22x22mm approx.) on which to rest. The
support must be securely fixed to the rear wall, the top surface of the support 35mm below
the worktop surface. A 15-18mm spacer panel must be fitted directly on top of this batton and
secured to the wall. The spacer panel should be slightly narrower than the spashback, but be
the same height i.e. 810x585mm. Finally the splashback can be installed; resting it on the
support batton there are 4 fixing screw positions, one in each corner. Screw into place using
a flange head Nº 6 woodscrew with a 2mm thick plastic washer to protect the glass. Make
sure utensil rail is at top.
IMPORTANT
•
This appliance must be installed into an aperture, sealed off at either side in order
to prevent draughts from adjoining cupboards/vents. Ensure that air vents and gas
escape holes are kept clear, holes for cables and pipes must be sized to minimize
air leakage between compartments.
•
Under no circumstances should the ventilation hole exceed 3850mm
2
or other low
level ventilation be located in the compartment, including vents in kickboards. Low
level vents in adjacent compartments are permitted.
WARNING
•
Do not over tighten the screws when fitting the utensil rail
•
Utensil rail and hooks must be fitted prior to Splashback installation.
WARNING
•
Do not over tighten the screws when fitting the glass splashback.
•
Splashback must be fitted prior to cooker installation.
Summary of Contents for OH88000NG PRODIGY 600
Page 2: ...2 ...
