10
Operating manual TwinSpin
®
G series reducers
•
Make sure that all bolt holes, screws and connecting adjacent surfaces are free of grease and dirt.
•
Assemble the motor flange to the input side of the reducer, use prescribed tightening torques.
•
Make sure that the splined shaft on the motor or the spline adapter is greased with special grease (see chapter
3.4 Reducer lubrication). Failure to do so will damage splined connection.
•
Slide the spline adapter on motor shaft, pull over the clamp ring and tighten with correct tightening torque. Use tightening
torque specified by clamp ring manufacturer.
•
Slowly insert the motor with spline properly oriented into the reducer input shaft. Please do not use excessive force or impact
to get the motor into a final position. Use gentle movement to adjust the splined shaft into counter-surface inside of the input
shaft.
•
Center the motor and tighten the bolts connecting motor to the motor flange.
Motor assembled with a reducer - spline connection adapter
4.5.2 Mounting with a spline connection
Motor
Motor Flange
Clamp Ring
Spline adapter
Reducer
