|
© 2019
SPIN SIGNATURES Installation Manual |
1
2
PRECAUTIONS
PRECAUTIONS
1. To ensure the success of the installation, be sure to read the instructions and study the diagrams thoroughly before commencing.
2. All electrical work should only be undertaken after disconnection of the power by removing fuses or turning off the circuit
breaker to ensure all pole isolation of the electrical supply. If you are in any doubt the services of qualified electrician should be
sought to ensure that all work is carried out in accordance with the l.E.E. Regulations and local wiring regulations, current good
practice and other national and local electrical codes.
3. Make sure that your installation site will not allow the rotation fan blades to come into contact with any object and that there is
minimum clearance of 150mm (6”) from the blade tip to the wall or ceiling. Please note that the bigger this clearance is, the better
the airflow from your fan will be. Ensure the blades are mounted at a height of 2.3 meters (7’6“) from the floor when the fan is
installed.
4. The fixing point for the fan must be able to support a weight of ten times that of the net weight of the fan. Net weight can be
found on the bottom of the unit’s box. The moving weight of the fan must not twist or work loose. For safety and best operating
results, you must have a qualified electrician to assemble and install your fan.
5. This appliance is not intended for use by persons (Including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
6. The fan must be earthed and should be installed with a double pole single throw switch (Breaker Switch) with minimum 3mm
contact gap in the fixed installation circuit.
7. Do not connect the fan motor to a dimmer switch. This may give an unsatisfactory performance (motor hum) and cause damages
to the motor. This will void the warranty.
8. It is not recommended that ceiling fans and gas appliances be operated in the same room at the same time.
9. After the fan is completely installed, make sure that all connections are secured tightly to prevent any problems.
10. Because of the fan’s natural movement, some connections may loosen. Check the support connections, brackets and blade
attachments twice a year to make sure they are all secure. If they are loose, tighten with a screwdriver (It is no necessary to take
the fan down from the ceiling).
11. This fan is only compatible with SPIN lighting products and remote control.
12. Do not insert anything into the fan blades while the fan is in operation. This will damage the blades and upset the balance of the
unit causing the unit to wobble.
13. For extra safety, contact SPIN Customer Care when in doubt with installation and check the fan every year to make sure there
are no loose parts.
14. SPIN recommends a thorough examination of the fan and its suspension once every two years, by the brand’s service team.
Service fees may apply accordingly.
