Copyright © 2020 Spiker Engineering. All Rights Reserved.
Push hard on the screw head as you are loosening it, to avoid camout and stripping:
If you do strip a screw and have to drill it out, a replacement screw is included in the kit. Or you can get the OEM
Toyota screw P/N 90159-60254, or M6-1.0 x 25mm, like these -
https://www.amazon.com/25-M6-Flange-Small-
Class/dp/B00N05XRMA
Pull the lower part of the handle away from the a-pillar, and slip the mounting bracket over the handle’s mounting post.
Note that the handle is usually “mushroomed”, so you may have to rock the bracket back and forth to slip it over the
mushroomed portion.
Once the bracket is installed over the handle, place the mounting post of the handle back into the a-pillar, and reinstall
the M6 screw (we recommend using the supplied high strength screw for easier future removals if necessary):
Place the adapter plate in front of the mounting bracket, and line up the holes, making sure that the cutout in the
adapter plate is on the right, as shown below. Secure the two brackets together with the bolt and nut provided. Don’t
fully tighten the nut at this point, to allow adjustments.
Install the Mounting Bracket