SPIERINGS SK599-AT5, Manual

Page: 186 / 238

SK599-AT5
Diesel engine truck
Truck
10-6 SPIERINGS MOBILE CRANES USER MANUAL V 0.1
D
ec
2
01
6
C
h
an
ges
an
d t
y
po
gr
ap
hi
c
al
er
ro
rs
res
er
v
ed.
©
20
1
6
S
pi
er
ings
M
obi
le
C
ran
es
–
A
ll r
ight
s
re
se
rve
d
.
10.2.3.2. Replacing oil filter element
The oil filter is situated at the right side of the engine.
Replacing the filter element ( Picture 10-7 ) must be carried out as follows:
1. Place an oil tray (of sufficient size) under the filter element;
2. Rotate the filter cover a few times and let the filter casing leak off;
3. Remove the filter cover with the filter element from the filter casing;
4. Remove the filter element out of the filter cover;
5. Replace the O-ring and lightly grease the new one;
6. Mount a new filter element (see § 14.1. Maintenance specifications );
7. Mount the filter cover back on the filter casing;
8. Tighten the filter cover with the tightening torque, which is mentioned on the filter cover;
9. Top up the engine with oil (see § 10.2.2. Topping up oil diesel engine truck ).
10.2.3.3. Topping up oil
Topping up the engine with oil must be done as mentioned below:
1. Remove the central cover plate of the engine cowling;
2. Top up the crankcase with oil (see § 10.2.2. Topping up oil diesel engine truck );
3. Close the filler neck by using the cap;
4. Start the engine and let it run for a few minutes;
5. Check the filter casing for leakage;
6. Mount the central cover of the engine cowling (see § 2.4. Engine cowling) ;
7. Fold the crane.
INFORMATION!
When replacing the new filter element, minimize touching the filter.
Touching the filter element may affect the operation of the filter and shorten the
service life.
Picture 10-7