SK599-AT5
Pneumatic system
Truck
SPIERINGS MOBILE CRANES USER MANUAL V 0.1
9-5
D
ec
2
01
6
C
h
an
ges
an
d t
y
po
gr
ap
hi
c
al
er
ro
rs
res
er
v
ed.
©
20
1
6
S
pi
er
ings
M
obi
le
C
ran
es
–
A
ll r
ight
s
re
se
rve
d
.
9.5.1.
Topping up oil atomizer
1. Make sure the diesel engine is not running;
2. Turn the
flask 5
) from the holder and top up the oil until the maximum level is
reached (see
§ 14.5. Specifications pneumatic system
3. Turn the flask with oil back into the holder;
4. Adjust the amount of sprayed oil by means of the
adjusting screw 4
.
9.5.2.
Performance water separator
The water separator is operating semi-automatically. If there is pressure on the air system, the valve
under the water separator will be pressed in. The condensate will be collected in the flask.
If there is no pressure on the air system, the valve will be opened and the condensate will drain off.
•
Press the valve to remove the condensate manually (see
1
);
•
Turn the valve clockwise to close it permanently (
2
).
9.5.3.
Replacing element water separator
For replacing or cleaning the filter element, the screw of the filter element must be loosened by means
of a special wrench (see
).
9.5.4.
Adjusting air pressure secondary air circuit
The pressure of the secondary air circuit (5.5 bar) can be adjusted by means of the pressure reducing
valve of the water separator.
For the values of these pressures, see the pneumatic diagram in the Annex.
1
2
A
Picture 9-6
