Spencer Logic User Manual Download Page 4

4.2 

Troubleshooting 

PROBLEM 

CAUSE 

REMEDY 

The device does not close 

Buckle broken or worn 

Use a similar device and contact the 
service center 

The fabric is torn 

The device has reached the end of its life or has 
not been used with due caution 

The device must be replaced 

 
5. 

MAINTENANCE AND CLEANING 

5.1  

Cleaning 

Failure to perform the cleaning operations can result in premature wear of the materials constituting the device. 
In the event of disinfection, use products that have no solvent or corrosive action on the materials constituting the device. 
Then  eliminate  any  trace  of  detergent,  which  could  degrading  or  compromising  the  integrity  and  durability.  Allow  to  dry 
thoroughly before storing. The drying after washing or after use in wet environment must be natural and not forced, do not 
use flames or other sources of direct heat. 

 
5.2 

Maintenance 

5.2.1 

Precautionary

 

maintenance

  

The  person  who  carries  out  the  precautionary  maintenance  of  the  appliance  has  to  guarantee  technical  knowledge  of  the 
appliance and of the periodic maintenance procedures as  described in these instructions. To perform maintenance  choose 
personnel who has specific qualifications, training and practice on the device in question. 
The checks to be carried out before and after each use, and at least every month, are as follows: 

 

General functionality of the device 

 

State of cleaning 

 

Presence of holes, cuts, abrasions 

 

Functioning of the locking and regulation mechanisms 

 

The  inspection  frequency  is  determined  by  factors  such  as  legal  requirements,  the  type  of  use,  frequency  of  use, 
environmental conditions during use and storage.

 Please note that you must do the cleaning as described in paragraph 5.1 

and verify functionality before and after each use. Spencer Italia S.r.l. declines any responsibility for the proper functioning or 
damages caused to the patient or user by the use of devices not subject to routine maintenance warranty and will void the 
CE compliance. 
 

5.2.2 

Periodic maintenance

  

Planned  interventions  by  the  Manufacturer  or  authorized  center  are  not  required,  but  it  is  prescribed  to  make  checking 
indicated in the specific section 5.2.1. 
 

5.2.3 

Special servicing 

Only the Manufacturer or centres with written authorisation are authorised to complete any special servicing operations.  

Spencer Italia S.r.l. will accept no responsibility for the incorrect functioning and/or damage caused by the use of any device 
which  has  not  been  repaired,  or  certified  on  expiry  date  by  the  Manufacturer  or  by  one  of  the  Manufacturer's  Authorised 
Service centres, making void both the guarantee and the CE conformity. 
 

6. ACCESSORIES AND SPARE PARTS 

There are nor accessories or replacement parts for this product. 
 

 

 

 

 

 

Warning 

The information contained in this document could be modified without any warning and is not to be intended as a commitment on behalf of Spencer Italia 

S.r.l. Spencer products are exported to many countries and the same identical regulations are not always valid. For this reason there could be differences 

between the description here described and the product actually delivered. Spencer continually strives to reach the perfection of all items sold. We 

therefore hope you will understand if we reserve the right, at any time, to modify the shape, equipment, lay-out or technical aspects that are herein 

described. 

 

© Copyright Spencer Italia S.r.l. 

All rights reserved.  

No part of this document can be photocopied, reproduced or translated into another language without the written approval of Spencer Italia S.r.l. 

Summary of Contents for Logic

Page 1: ...or the production and the final control of the products certified by the notifying body TÜV SÜD Product Service GmbH INDEX General information page 2 Warnings page 2 Product description page 3 Operating instructions page 3 Maintenance and cleaning page 4 Accessories and spare parts page 4 First edition 20 12 2013 Rev 0 20 12 2013 ...

Page 2: ... each country 1 6 Labelling Each device has got an identifying label positioned on the device itself and or on the box This label includes information about the manufacturer the product the CE mark the lot number LOT It must never be removed or covered 2 WARNINGS 2 1 General warnings The product must be used by trained personnel only having attended specific training for this device and not for si...

Page 3: ...sary information for carrying out periodical checks on their devices as specified in the relevant user s manual Actively contribute to product safety checks on products sold by communicating any relevant risk analysis information both to the manufacturer and to any competent authorities so that the necessary action can be promptly taken The distributor or final user is aware that in the event of a...

Page 4: ...s described in paragraph 5 1 and verify functionality before and after each use Spencer Italia S r l declines any responsibility for the proper functioning or damages caused to the patient or user by the use of devices not subject to routine maintenance warranty and will void the CE compliance 5 2 2 Periodic maintenance Planned interventions by the Manufacturer or authorized center are not require...

Reviews: