Spellman SPX Series, Manual

Page: 26 / 51

SPX X-ray
Industrial Imaging System
Page 24 of 44 SPX Series System Manual
118173-001 Rev. D
SPX Series Control
Connections
The SPX Controller interfaces with all of the
necessary power and signal cables for operation
of the system. Each connector plug / receptacle
identified with a label incorporates a dedicated
military style connector for ease of connections.
Fuses- A set of 20 ampere fuses protect the main
power circuitry while a set of 10 ampere fuses
protect the cooler power circuitry A fan with an air
filter circulates air within the chassis while the unit
is in operation. Figure 4-3.
Controller Power Cable - Terminated with a
120V standard plug and a 3-pin Cannon
connector (3106-16-10) that mates with the power
input connector (J1). Figures 4-4 and 4-5.
Tube Head Interconnect Cable
–
Cable fitted
with two military style connectors at a minimum of
100’ in length (J3). Figures 4-6, 4-7, 4-8 and 4-9.
Cooler Power/ Interlock Cable
–
Provides power
to the cooling unit for either air-cooled or water
cooled units and monitors the flow rate in liquid
cooled units to prevent overheating to the X-ray
tube. (J2) Figures 4-10 and 4-11.
Interlock / Indicator Cable
– Provides customer
X-ray status indicators and system safety interlock
connections. (J4) Figures 4-12 and 4-13.
Cooling Hose (Liquid Cooled Units)
–
Provides
coolant flow between the Cooler Unit and the
Tube Head. Figures 4-15 and 4-16.
Figure: 4-5 Power Input Cable
Figure: 4-3 SPX Control Side Panel
Figure: 4-4 Power Cable Detail