Spellman SPX Series, Manual

Page: 11 / 51

SPX X-ray
Industrial Imaging System
Page 9 of 44 SPX Series System Manual
118173-001 Rev. D
Chapter 2
:
Preparation for Use and Shipment
UNPACKING INSTRUCTIONS
The SPX X-ray Unit is shipped in a single wooden
container. To gain access to the unit, perform the
following:
◆
Remove the top cover from the crate.
◆
Carefully lift each component from the
container.
◆
Perform a thorough visual
inspection on each component.
If damage to any component has occurred,
immediately contact the carrier. Keep all damaged
containers until the carrier completes an inspection
by the carrier. If it is necessary to re-package and
ship the unit, follow the instructions outlined under
“Reshipment Guidelines”.
Reshipment Guidelines
In the event that the SPX X-ray Unit must be
transported or shipped, use the original wooden
container and packaging material whenever
possible. If the original shipping material is not
available, comply with the following re-packing
guidelines.
1.
Construct a wooden shipping carton for
the Tube head Assembly similar to the
one in Figure 2-1. Build the carton so that
the top can be completely removed to
facilitate packing and unpacking.
2.
Cushion the Tube head with 3" of
shock absorbent, foam type, packing
material (MINIMUM). This material
MUST surround the assembly on all
sides, including above and below the
Tube head.
3. Affix supporting blocks to the bottom
of the carton. Make sure the legs are
positioned to accommodate a pallet
jack as shown in Figure 2-1.
4. Pack the Control Unit in a
container rated for 60 lbs.
surround the Control Unit with a
MINIMUM of “2" of shock
absorbent packing material (sheet
or loose type), including the top
and bottom.
5. Pack the Cooling Unit in the
same manner as the Control Unit.
! WARNING!
The coolant solution is a flammable
substance and must be drained from
the Cooling Unit’s reservoir before it
can be shipped.