7. Using a straight edge, mark the location of the 1/2A
control horns on the elevons.
8. Mount the control horns making sure that the push-
rod holes are directly above the hinge line. You will
need to use a drill bit to make holes in the elevon for
the control horn screws.
9. Connect a pushrod to the control horn and hold the
elevon level. Mark the pushrod where it goes over the
servo control horn. (Note: I use the second hole from
the top on the elevon control horn and the second hole
from the bottom on the servo horn).
10. Make a Z-Bend in the pushrods where you
marked them using a Z-Bender or a small pair of
pliers. Cut off the excess pushrod and attach to your
servos.
11. Attach the motor using the tie wraps included in
your kit.
12. Cut the covering off of the cooling holes in the
speed control cover. You can cut them off of the re-
ceiver cover as well, but it isn’t necessary.
