RugBuddy
™
Portable Heater for under your Area Rug!
Models: USC.1410.11.120 ∙ USC.940.11.120 ∙ USC.470.11.120
Speedheat® is Floor Heating
A
REA
R
UG
I
NSTALLATION
1.
Place the
area rug over the heating panel.
Note:
•
For best results, cushion pad should be at
least ½-
inch larger than the heating panel
on all four sides. If it is not,
the heating panel
.
Unless negligible, a different
may be required.
•
There is no top or bottom of the
RugBuddy™
.
You may flip the heating
panel whichever way i
s most convenient
for your installation.
•
The power supply cord
the corner of the heating
over the cord.
2.
Attach the area rug to the cushion or padding with strong
Tape at:
Each corner
At least one additional place along
IMPORTANT!
•
NEVER Fold over
the RugBuddy™ while in operation or allow it to operate
completely flat with NO CREASES or FOLDS!
3.
Plug the GFCI plug in to the 3
-
Press
TOP “Reset”
button.
o
You should notice a
If not,
press BOTTOM button
4.
Wait about 20 minutes
, and
lay
If instructions are
followed properly, y
temperature difference to the surrounding, unheated floor.
If not, see
TESTING and TROUBLESHOOTING
USC.470.11.120 ∙ USC.370.11.120 ∙ USC.165w.11.120 ∙ USC.165L.11.120 ∙ USC.065.11.120
area rug over the heating panel.
For best results, cushion pad should be at
inch larger than the heating panel
on all four sides. If it is not,
DO NOT cut
Unless negligible, a different
RugBuddy™
size
There is no top or bottom of the
You may flip the heating
s most convenient
The power supply cord
, which is located in
the corner of the heating
panel,
should be kept clear of walkways so that people do not trip
Attach the area rug to the cushion or padding with strong
double-
sided adhesive tape
At least one additional place along
each edge.
the RugBuddy™ while in operation or allow it to operate
completely flat with NO CREASES or FOLDS!
-
prong, grounded outlet.
You should notice a
RED LIGHT
on GFCI plug.
press BOTTOM button
then,
“Reset”
again.
lay
on top of your area rug for 5 minutes
.
followed properly, y
ou should feel a 10 – 15° F
temperature difference to the surrounding, unheated floor.
TESTING and TROUBLESHOOTING
on Page 1 of this manual.
Operating Instructions
and Safety Advice
∙ USC.065.11.120
Page 4 of 5
should be kept clear of walkways so that people do not trip
sided adhesive tape
.
the RugBuddy™ while in operation or allow it to operate
unless
it is