5
MicroStar B
Service manual
MicroStar B
rev06
09
09
09
09
09
Safety and note
1.1
Please read these notes carefully before powering up the drive
Warning!
Simbols security standard
Caution
Danger Sign
All the circuits in the Drive are potential sources of severe electrical shock, so follow these
rules to avoiding possible personal injury.
- Power off the drive and wait until all the leds are turned off before touching, removing,
connecting or any other critical action.
- Never disconnect any connectors before powering down the drive
Warning of Current being present
In case of doubt or in any case you don’t know as to behave yourself, before access to the
drive, power off the device and wait until all the leds are turned off.
May you have attention when you touch the drive because it may be hot.
Warning
It's used where the intent is to highlight useful considerations, prescriptions, indications,
and the correct execution procedures of every type of intervention and prevention of
damaging both systems and drives.
General Security Directives
Along with what is prescribed in the manual, pay attention to the security directives for
prevention of accidents and risks.
Always remove the power supply (disable) from both the system and the drive prior to any
type of intervention on electric or mechanical parts.
It is very important meet all applicable safety requirements during installation and operating
of any motion control equipment. Any installer has to assume the responsibility to ensure
that he recognizes and complies all the relevant safety standards. Any installation, not
meeting the safety requirements, may damage the equipment or injury the user.
This motion control equipment shoul be handled, installed, setted-up and maintenanced
only by competent personnel expert and trained in the installation of motion control electronic
equipment. Such technicians should be aware of potential electrical and mechanical
hazards. Shall never beliable or have any responsability if the products have been improperly
stored, installed, used or maintened, or if the costumer has permitted any unauthorized
modifications, adjustments, and/or repairs to the products.
Users must keep well clear in mind that this motion control equipment is capable of
producing high forces and rapid movement so they must be used with attention especially
during the application program’s development.
This motion control equipments are sold as end-users products to be installed only by
practical staff in accordance with all local safety laws and regulations. The device have to
be enclosed such that any part is not be accessible while the system is powered on.
We strongly reccomend to follow these recommendations in order to avoid wrong uses of
the equipment that may be impaired all the protections provided by the device.
