5
FIGURE 6
FIGURE 7
10. Assemble the wheel support to the cart using eight
5/16" x 3/4" truss head bolts and 5/16" hex nuts as
shown in figure 6. Heads of bolts go on the inside
of the cart. Tighten.
FIGURE 5
9. Assemble the front panel over the end of the cart
using six 1/4" x 1/2" hex bolts and 1/4" hex nuts as
shown in figure 5. Leave two holes in the bottom of
the panel empty as shown. With the cart body
halves pulled together, tighten the bolts in the
bottom of the front panel, then tighten the bolts in
the sides. See figure 5.
At this time tighten the bolts assembled in step 4,
which fasten the bottom of the cart together.
FIGURE 8
12. Assemble the two corner caps to the front corners of
the cart using four 1/4" x 1/2" hex bolts and 1/4" hex
nuts. Also assemble two 1/4" x 1/2" hex bolts and
1/4" hex nuts to the two rear corners of the cart.
TIGHTEN. See figure 8.
11. Turn the latch stand bracket so that the aligning tab
is at the rear (bottom) of the bracket. Assemble the
latch stand bracket to the cart using four 1/4" x 1/2"
hex bolts and 1/4" hex nuts. TIGHTEN. See figure 7.
1/4" x 1/2"
HEX BOLTS
1/4" HEX NUT
1/4" HEX NUT
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
5/16" HEX
NUT
WHEEL
SUPPORT
5/16" x 3/4"
TRUSS HEAD BOLT
1/4" x 1/2"
HEX BOLT
LATCH STAND BRACKET
1/4" HEX NUT
ALIGNING TAB
AT BOTTOM
CORNER CAP
1/4" x 1/2"
HEX BOLT
1/4" HEX NUT
1/4" HEX
NUT
ENGLISH
