2
ASSEMBLY INSTRUCTIONS
1.
Raise Handle Tubes to the upright operating position
and tighten the (4) Wing Nuts.
2.
Attach the Flow Control Assembly to the inside of the
Handle Tube as shown.
ADJUSTING THE FLOW RATE SETTING
1.
Slide the Adjustable Stop to the desired setting.
2.
Move the Flow Control Lever forward and snap it into
the Adjustable Stop to lock it into the on position.
FIGURE 1
FIGURE 2
OPERATING INSTRUCTIONS
FLOW CONTROL LEVER
ADJUSTABLE STOP
5
1
3
7
10
OFF
MAINTENANCE/STORAGE
CHECK FOR LOOSE FASTENERS
1.
Make a thorough visual check of the Spreader for any
bolts and nuts which may have loosened. Retighten
any loose bolts and nuts.
CLEANING
1.
Always empty spreader after each use, storing left-
over material in it's original bag.
2.
Wash the spreader and dry thoroughly after each
use.
STORAGE
1.
Empty and clean the hopper as instructed in mainte-
nance section.
2.
Store in a clean, dry area.
USING YOUR SPREADER
1.
Check the material package and the Spreader Set-
tings sheet included with your spreader for the proper
spreader setting and application rate.
2.
Before filling spreader, push the control lever to the
"OFF" position.
3.
Move spreader onto a flat surface - either a walk or a
driveway - and fill.
4.
Set the Adjustable Stop to the desired setting.
5.
Start the spreader in motion and then move the
control lever forward to the "ON" position as you walk
across your lawn.
NOTE: Always place control lever in the "OFF" position
while filling spreader and when stopping or turning, to
prevent release of excess fertilizer.
APPLICATION TIPS
1.
To avoid misses or striping, overlap the previous
wheel tracks by approximately 3 inches.
2.
For easiest application, spread across the shortest
edges of lawn first, making two "header" strips for a
turning area, and then spreading between the header
strips. See figure 1.
3.
If lawn is odd shaped, spread a border around the
edges and then spread between the border. See
figure 2.
IMPORTANT: Be careful when using spreader around
ornamental plants because weed controls can dam-
age these plants.
RULES FOR SAFE OPERATION
The following safety precautions are suggested. This
broadcast spreader is designed, engineered and tested
to offer reasonably safe and effective service, provided it
is operated in strict accordance with these instructions.
Failure to do so may result in personal injury. Always
observe the rules of safe operation.
1.
Do not allow anyone to operate the spreader without
proper instructions.
2.
Do not permit children to operate the spreader.
3.
Wear eye and hand protection when handling and
when applying lawn or garden chemicals.
4.
Read the label instructions and cautions for handling
and applying the chemicals purchased for spreading.
5.
Keep all nuts, bolts and screws tight to be sure
equipment is in safe working condition.
6.
Follow maintenance and lubrication instructions as
outlined in this manual.
