SC-TC-60
6
Model SC-TC-60 Operating and Maintenance Manual
The SC-TC-60 tube cleaner uses a brush on the end of a rotating, polymer-encased flexible
steel shaft. As the operator feeds the rotating brush/shaft assembly through the tube, the brush
or tool loosens any deposits (mud, sand, etc.) and water flows through the casing to flush them
out. A solenoid operated ball-valve controls
the water flow.
The SC-TC-60 with a ½ HP (0.4 kW)
motor is designed for cleaning
tubes and pipes ¼”-1” (6.4-25.4mm)
I.D. It is a compact, self-contained,
carry-anywhere unit which permits
operation in tight quarters.
Overview
1
1. Quick Connect Latch
2. Latch Lock
3. Carry Handle
4. GFCI Power Cord
5. Garden Hose Connector
6. Foot Pedal
2
3
4
5
6
Operating Instructions
SC-TC-60
Pre-Operation Checklist
✓
Check for adequate water supply. Use no smaller than a 5/8” garden hose for
water supply.
✓
Check ground fault circuit interrupter (GFCI). Test & reset.
✓
Check all connections.
Connecting Flexible Shaft
1. Select the proper size flexible shaft (SC-TC-S02, SC-TC-S03) for
tube diameter and length to be cleaned.
2. Insert square end of flexible shaft into the square in the drive
shaft of the machine. The shaft may have to be turned up to
90 degrees for alignment.
3. Push flexible shaft strain relief into quick connect latches and
turn locking peg to lock shaft in place.
Latch Lock moves to the UP
position to lock and DOWN to
unlock.
Latch Lock