Component Testing Information
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to washer before servicing, unless
testing requires it.
August 2000
3
RT3100015 Rev. 0
Illustration
Component
Test Procedure
Results
038424W
Rocker switch
(Extra Rinse)
Measure resistance of switch
positions:
Closed (ON position)
Open (OFF position)
Continuity
>1
Ω
Infinite
1 M
Ω
R0000014
Brake pad kit
If washtub does not stop spinning
within seven seconds after opening
loading door.
If brake pads make noises.
Replace all three brake pads.
Apply a thin layer of silicone (26594P) on
pads, see Service Bulletin
“ASQ
−
213
−
B”
40095001
Motor
Type of motor:
Two speed
See following section “Internal Motor
Diagram and Schematic” for correct
wiring contacts.
40040301
Drain pump
Verify drain pump is not clogged or
damaged.
Remove clog and verify proper operation.
Replace drain pump if damaged.
40065301
Transmission
assembly
Type of transmission:
640 rpm
Externally identical, must be identified by
part number.
If transmission locks-up, replace.
40053602
Drive belt
Type of drive belt:
640 rpm
Refer to “Parts Manual” for proper
pulley size.
Refer to “Parts Manual”, to verify which
drive belt and pulley size is required.
