0113214R8 Page 3 of 12
Wire management trays
The trays can easily be moved to the upper position to provide an additional
7
⁄
16
” (1.11 cm) of height to the tablet device storage area below if needed.
The trays are factory-installed in the lower position to provide additional
clearance for chargers and wires in the tray. In this position, the trays accom-
modate most brick-style chargers on the market.
To raise the tray:
1. Open all doors as far as possible.
2. Pull out one of the trays from the power-side.
Figure 2
.
3. Locate the black plastic slide release levers on each side of the tray. Release the levers while
pulling the tray out from the slides.
Figure 3
. Set the tray aside.
4. With a Phillips screwdriver, remove the existing (4) 8-32 x 1/2” PH thread-cutting screws from
one of the outer slides.
Figure 4
. Move the outer slide to the upper position and attach using
the (4) previously removed 8-32 screws. Repeat this same procedure on the other slide.
5. To re-install the tray, re-align the inner and outer tray slides and push the tray back into place.
6. Repeat these same steps on the second tray (InTouch 40 only).
Phillips
screwdriver
Tools
Required
upper position
(use for taller tablet devices)
lower position
(
factory-installed position)
8-32 x 1/2” PHMS
(4 required per slide)
outer slide
Figure 2
Figure 4
Figure 3
plastic
release
lever
Upper tray position:
7
⁄
8
” (2.22 cm) charger height available
9
9
⁄
16
” (24.26 cm) device-height available
Lower tray position:
(factory-installed)
1
5
⁄
16
” (3.33 cm) charger height available
9
1
⁄
8
” (23.18 cm) device-height available
Wire management tray position
wire management tray
