Drum Set Assembly Instructions
3
Mounted Tom Assembly – to Bass Drum
1. Set desired height of support arms using thumb
screws on tom mounting base (located on top of
bass drum).
2. Loosen support collar 1. using drum key
(E)
.
Then, slide collar down to fit into mounting base.
Make sure to align collar nub into indentation on
mounting base.
3. Set angle of support arm to recommended 80
degrees and tighten thumb screw.
4. Using drum key
(E)
loosen support collar 2.
5. Slide mounted tom drum onto support arm and
tighten support collar 2. The mounted tom drum
should be located to the left when drumming.
Cymbal Stand Assembly
1.
Extend legs into open position.
2.
Slide upper tubes into base and set desired
height
using set screws
3.
Place cymbal between felt cushions.
Leave thumbscrew somewhat loose to allow
cymbal
freedom to move when struck.
4.
Set desired angle of cymbal using swivel
adjustment.
Attaching Bass Drum Pedal or Beater
1. Insert the bass
drum beater into the
bass drum pedal
and tighten with the
drum key
(E)
.
2. Attached bass
pedal to the bass
drum hoop using
the toe clamp.
3. Tighten the
wingnut on the toe
clamp until secure
