0117128R5 Page 2 of 10
• Read this owner’s manual before assembly or operation.
• Do not allow children to move the table.
• For indoor use only. Do not install or store the table where it will be
exposed to moisture.
• Do not block the ventilation openings.
• Do not allow anyone to sit, stand, or climb on the table.
• Use a damp, soft-cloth, or sponge, with mild soap or detergent solution
to clean dirty surfaces. Do not use harsh solvents or abrasives.
• This table is intended for institutional use. It does not have any user-
serviceable parts or user-maintenance requirements. If servicing is
necessary, please contact Spectrum Industries for assistance.
General Electrical Safety:
• Keep power switches in the OFF position before plugging or
unplugging from the wall outlet.
• Be sure total device / equipment load does not exceed 12-amps.
• Do not plug power cords into an extension cord.
• Inspect power cords for damage before each use. Do not use cords
that are damaged.
• Unplug power cord from electrical outlet by gripping the cord-do not
unplug by pulling only on the cord.
• Do not step on, drive over, drag, or place objects on power cords.
• For added safety, plug into a grounded outlet controlled by a GFI
(Ground Fault Interrupter) circuit breaker.
•
Damaged electrical components can create signifi cant hazards to
users and is not covered by the warranty. Repairs should always be
performed by a qualifi ed electrician.
• Electrical devices are not toys. Children are often unaware of the
hazards associated with electrical devices. This table must always
be used by adults or with adult supervision.
Warning
- Relocating audio and/or video equipment to furniture not specifi cally
designed to support audio and/or video equipment may result in death or
serious injury due to the furnishing collapsing or over turning onto a child.
Warning
- Death or serious injury may occur when children climb
on audio and/or video equipment furniture. A remote control or toys
placed on the furnishing may encourage a child to climb on the
furnishing and as a result the furnishing may tip over on to the child.
Important Safety and Care Instructions
Assembly / Setup
1. Unlock monitor column
Note: Every Flex Insight Desk ships with one or two carriage bolts with wing nuts
locked in a keyhole slot under the bottom of the keyboard tray. These fasteners
prevent monitor column movement during shipping, and will need to be removed to
get the monitor column to function. A picture of the bolt and wing nut is shown here
from the back side of the desk. To remove, unscrew the wing nut by hand, and slip
the bolt out of the keyhole slot. The fasteners should be retained for reuse if you
will be transporting the desk.
If you transport the desk (in a trailer or truck) it is recommended to replace the
carriage bolt and wing nut. To replace, start the wing nut on the end of the bolt and
push the monitor column down into the lowered position. Wiggle the head of the
bolt into the slot from the large side of the keyhole. Let the monitor column rise
slightly to put tension on the wing nut. Tighten down until monitor column does not
move and is secure.
Carriage bolt
Keyhole slot
Wing nut
Monitor column
Figure 1
Hardware
Standard Swivel VESA Monitor
Mount with internal travel stops
provides 4-direction tilt, and works with
75mm and 100mm VESA monitor mounts
(includes mounting screws)
(2) 0107624
(15) 0102376
11” Zip ties
(1) 025069
Glide wrench
(4) 052605
1/4-20 x 15mm
JC bolts
(1) 0107574
Unit-to-unit
bracket
(1) 025039
4mm Hex wrench
(4) 037779
5/16-18 x 1”
Glide
