2. Assemble Table
0119685 Page 3 of 4
1. Place the worksurface face down onto a non-abrasive surface.
2. Attach the leg as shown with (8) 1/4-20 x 5/8” PHM screws.
Figure 2A
. Tighten securely.
3. Attach the (2) casters or (2) glides to the bottom of the leg and tighten securely.
4. Attach the modesty panel to the worksurface with (4) #8 x 3/4” PHSM screws.
Figure 2A
shows a right-hand table installation.
Note:
Figure 2A
shows a right-side table assembly.
If assembling a left-side table, the modesty panel can
be flipped and attached to the opposite side of the
worksurface using the other set of predrilled holes.
Figure 2A
Figure 2B
Modesty
Panel
Worksurface
5. Attach the modesty panel to the leg with
(3) 1/4-20 x 5/8” PHM screws.
Figure 2B
.
Leg
1/4-20 x 5/8”
PHM screws
(8 required)
(2) Casters or
(2) Glides
When assembling a left side
table, use this set of 4 holes to
attach the modesty panel
Modesty
Panel
1/4-20 x 5/8”
PHM screws
(3 required)
#8 x 3/4”
PHSM screws
(4 required)
Modesty Panel
flush with work
-
surface edge
Note: The fastener slots in the mod-
esty panel allow slight adjustment
with the worksurface. The modesty
panel should be attached flush with
the edge of the worksurface.
