057859R6 Page 2 of 4
2. Install modesty panel / cord channel, and glides
1. Orient the modesty panel/cord channel as shown and attach
to the legs with (4) 1/4-20 x 5/8” PHM screws.
Figure 2A
.
2. Install the (4) glides to the bottom of the legs. The glides can
be adjusted later to keep the desk level on uneven surfaces.
3. Tighten ALL screws.
Note: If you are assembling a 60, or 72” desk, slide the
cord channel over the chair rail brackets. The brackets will
support the inside of the cord channel.
Figure 2B.
Figure 2B
Figure 2A
modesty
panel / cord
channel
1/4-20 x 5/8” PHMS
(4 required)
glides
(4 required)
chair rail bracket
cord
channel
Adjustable legs
If you have a desk with the adjustable leg feature, the worksurface height can be adjusted from
24”H - 32”H in 1” increments.
Figure 2C
. Adjustment is easier if the desk is upside-down.
1. To adjust the legs, remove the (4) pre-installed adjustment screws.
(Fully-support the lower section of the leg while removing).
Figure 2D
.
2. Choose a height and align the corresponding set of leg holes.
3. Install the (4) previously removed screws in the new holes and tighten securely.
4. Repeat this procedure on the second leg. Make sure to use the same set of holes
used on the first leg.
Figure 2C
Figure 2D
lower section
up to 8” of
adjustment
up to 8” of
adjustment
adjustment
screws
