Flat panel
monitor
3. Installing Flat Panel Monitor
A. Loosen the back panel JC bolts slightly with a 4mm hex wrench, lift off the back panel, and open the monitor compartment lid
B. Attach the Swivel VESA mount to your flat panel monitor with (4) 4mm PHM screws.
Figure 3A.
Note: On most flat panel monitors, it will be necessary to remove the standard base that comes with the monitor to use the
VESA mounting option
.
C. Position your monitor with the lift column and align the VESA mounting holes with the lift column slots. Leave a small gap between the
top of the monitor and lift bracket to provide clearance for the monitor to fully tilt.
D. Attach the swivel VESA mount and monitor to the lift column with (4) 10-24 x 1/2" screws as shown in
Figure 3B
.
Tighten screws securely.
(4) 10-24 x 1/2"
screws
Figure 3A
(4) 4mm PHMS
Swivel VESA
mount
Figure 3B
Lift column
Lift bracket
Swivel VESA
Mount
4. Installing CPU
A. Set the CPU unit into the CPU sling.
B. Make sure the CPU will be supported by both straps. Tighten the straps around the
0107821XR3 Page 4 of 12
Flat panel
monitor
3. Installing Flat Panel Monitor
A. Loosen the back panel JC bolts slightly with a 4mm hex wrench, lift off the back panel, and open the monitor compartment lid
B. Attach the Swivel VESA mount to your flat panel monitor with (4) 4mm PHM screws.
Figure 3A.
Note: On most flat panel monitors, it will be necessary to remove the standard base that comes with the monitor to use the
VESA mounting option
.
C. Position your monitor with the lift column and align the VESA mounting holes with the lift column slots. Leave a small gap between the
top of the monitor and lift bracket to provide clearance for the monitor to fully tilt.
D. Attach the swivel VESA mount and monitor to the lift column with (4) 10-24 x 1/2" screws as shown in
Figure 3B
.
Tighten screws securely.
(4) 10-24 x 1/2"
screws
Figure 3A
(4) 4mm PHMS
Swivel VESA
mount
Figure 3B
Lift column
Lift bracket
Swivel VESA
Mount
4. Installing CPU
A. Set the CPU unit into the CPU sling.
B. Make sure the CPU will be supported by both straps. Tighten the straps around the
CPU while keeping the buckles positioned as high as possible to avoid interference.
Figure 4A
.
Note:
The center slot can be used for better support of smaller profile CPU's.
If the center slot is necessary, take the rear strap out of the rear slot and thread
into the center slot shown in
Figure 4A
. Thread the strap as shown in
Figure 4B
.
Figure 4B
Figure 4A
CPU
CPU sling
straps
Strap/buckle
assembly
Center slot
CPU
CPU Sling
0107821XR3 Page 4 of 12
