Figure 2
2. Attach Legs
A. Set a leg on each leg mechanism.
Figure 2
.
B. Attach each leg with the included hex screws (4 per leg) and hex wrench.
C. Tighten screws securely.
D. Be sure swivel wheels are tightened securely.
(Tighten with 1/2" wrench if necessary.)
E. Carefully tip the table upright- this will require two people.
Leg
Mechanism
Leg
Leg
Leg Mechanism
Hex screws (4 req'd)
Figure 3A
Spring clip button on each
leg provides 9" of total height
adjustment in 1" increments
0108517R2 Page 2 of 3
3. Table Operation
●
To adjust the worksurface height, press the spring clip button on one leg and raise or lower the worksurface and upper leg assembly (slightly
twisting then sliding the leg after the button has been pressed will help keep it retracted until its aligned with the new hole.)
Figure 3A
. Align the
spring clip button with one of the adjustment holes to lock the leg into the new position. Repeat this procedure on the other leg while making
sure to use the same hole position on both legs.
●
To flip-up the worksurface, pull the release lever while lifting up the edge of the worksurface until it locks into place.
Figure 3B
. To lower, pull
the release lever while lowering the worksurface-be sure it locks into place. Multiple desks can be “nested” together next to a wall to save space.
Figure 3C
.
Figure 3B
Figure 3C
0108517R2 Page 2 of 3
