Spectrex SharpEye 40/40I, User Manual

Page: 45 / 85

TM 40/40I, Rev (14) February 2017
Configuring Your Detector 45
2.8.4 Function Setup
You can select the desired functions as detailed in Table 17.
Table 17: Functions
Function Setting
Alarm Latch

Yes: Enable Alarm latching.

No: Disable Alarm latching (default).
Auxiliary Relay*

Yes: Activate Auxiliary Relay at Warning level.

No: Activate Auxiliary Relay at Alarm level
(default).
Automatic BIT

Yes: Perform Automatic & Manual BIT (default).

No: Perform Manual BIT only.
Alarm BIT

Yes: Successful Manual BIT activates the Alarm
Relay for approximately 3 seconds (default).

No: Successful Manual BIT does not activate the
Alarm Relay.
Auxiliary BIT*

Yes: Successful Manual BIT activates the
Auxiliary Relay for approximately 3 seconds
(default).

No: Successful Manual BIT does not activate the
Auxiliary Relay.
EOL*

Yes: Auxiliary Relay is used as End of Line.

No: Auxiliary Relay operates in accordance with
Functions 2 and 5 (default).
Note : * Only available in Models 40/40I-4XXXX and 5XXXX
2.8.5 Heated Optics
The heated optics can be defined as one of the following modes:
 Heated Mode
 Off: Not operated
 On: Continuously
 Auto: Per temperature change
In Auto mode, the default Heat On setting is 41°F/5°C. Heating stops when
the temperature is 27°F/15°C above the start temperature.
You can define the start temperature below which the window will be
heated. The temperature can be defined between 32
– 86°F / 0 – 30°C.
www.acornfiresecurity.com
www.acornfiresecurity.com