SpectraLink Corporation
Installation and Operation
Link WTS – Link 150 M3 MCU
8.4 Replace a Wireless Telephone
If a Wireless Telephone breaks or needs to be replaced, the old Wireless Telephone must
be deleted and the new Wireless Telephone added.
Delete Old Wireless Telephone
1. Make sure all unregistered Wireless Telephones are
OFF
. If this is not done an
unregistered Wireless Telephone may unintentionally register to an available line.
2. Move the mode switch to the
REGISTER
position on the MCU.
3. Press the
STEP
button until the LED for the line to be deleted is flashing red.
4. Press the
DEL/ENTER
button.
You can now register a new Wireless Telephone or return the mode switch to the
NORM
position.
Register New Wireless Telephone
1. Make sure all unregistered Wireless Telephones are
OFF
.
2. Move the mode switch to the
REGISTER
position.
3. Press the
STEP
button until the desired line to be registered is flashing red. Only
unregistered lines can be registered.
4. Press
PWR
on the Wireless Telephone that needs to be registered. The LED
should change to mostly on once theWireless Telephone is registered.
5. Wait at least three seconds and then press
END
.
6. Return the mode switch to the
NORM
position.
7. To assign the extension number, hold down the
FCN
key until Volume Level
displays. Press the
# >
key (NEXT) until EXTENSION displays on the Wireless
Telephone. Press
0
, then enter the correct extension number.
8. When the Wireless Telephone is turned
ON
, the extension will be displayed. Test
the Wireless Telephone by placing a call to each Wireless Telephone to verify
that the correct Wireless Telephone rings.
Part Number: 72007501D.doc
Page 43