Spectracom VelaSync 1225, User Manual

Page: 233 / 272

Command Description
slaacset Used to enable or disable SLAAC
stateset Enable or disable an entry in the reference priority table. index = 0...15. state
= 0 (disable), 1 (enable)
status Displays information about the oscillator disciplining
syncstate Display timing system synchronization state
sysupgrade Performs system upgrade using the update bundle provided
testevent Generates SNMP events in the enterprise MIB
tfomget Displays current estimated system time error (TFOM – Time Figure of
Merit)
timeget Displays current system time (time is displayed in the configured timescale
– See
scaleget command to retrieve the configured timescale)
timeset Used to manually set the current time (hours, minutes in seconds); time is
entered based on the configured timescale – See
scaleget command to
retrieve the configured timescale
unrestrict Used for clearing access control restrictions to VelaSync
version Displays the installed main VelaSync and timing system software versions
yearget Displays the current year
yearset Used to set the current year
zeroize Applicable to SAASM-equipped VelaSync units only
5.3 IRIG Standards and Specifications
5.3.1 About the IRIG Output Resolution
The IRIG output signals are generated from VelaSync's System Time, which can be
synced to one or more external input references (such as GPS, IRIG, PTP, etc). The
accuracy of the System time to true UTC time is dependent upon what the selected
external reference is (with GPS typically being the most accurate reference for the sys-
tem to sync with).
IRIG AM synchronization of a device to its IRIG source is typically measured in the tens
of microseconds, while synchronization using a IRIG DCLS signal can typically provide
VelaSync User's Manual 221
APPENDIX