59
RTK or DGPS Rover
On the receiver’s General Status screen, the receiver will
display “FIXED” (with short “FLOAT” transition time) or
“DGPS” when computing a position respectively in RTK or
DGPS mode. The computed position is displayed after
pressing .
When corrections are received and used,
is displayed on
the General Status screen together with the age of corrections
(see
To configure the receiver as a DGPS or RTK rover, use the Web
Server as follows:
• Go to
Receiver
>
Position
>
Rover Setup
.
• Set
Processing Mode
to
RTK
.
• Specify how the corrections are forwarded to the receiver
by setting
Input Mode
accordingly. If you choose
Automatic
,
the receiver will find by itself which of its ports is used to
acquire corrections. If you choose
Manual
, you need to
specify this port.
• Additionally, in the
Other Settings
section, you may change
the primary GNSS system used (
GPS
is the default
selection), limit the level of position accuracy to less than
what the receiver can actually achieve in this case.
Typically you will choose
RTK Position
or
(RTCM) Differential
Position
to match with the selected operating mode
(respectively RTK or DGPS).
• Select the model of dynamics that suits the movement
pattern of your rover best.
• Click
Configure
.
• Set the device used by the receiver to acquire corrections:
–
If corrections are received via radio, go to
Receiver
>
Radio
to enter all radio parameters. You may use the
internal radio or an external radio.
1
XYZ or
Lat-Lon-Height
Position
One set of corrections via:
• Internet (Ethernet, cellular modem, or WiFi), or
• UHF Radio
