TROUBLE SHOOTING (CONTINUED)
26
Error
Cause & Solution
Laser Will Not
Self-Level
(All Laser Levels)
Outside Levelling Range Or Impact Damage
If the
Laser Level
is positioned outside of it’s self levelling range
of ±5 degrees the rotating laser prism will tilt over to one side (to
try and locate a level position) and then time-out.
Re-position the
Laser Level
so that is is within ±5 degrees of level
and try again.
If it’s within ±5 degrees of level and the prism remains tilted over
to one side, turn the laser OFF and On again and try again. If the
laser will still not self level, it may have received an impact which
has aff ected the self levelling system.
Please contact the Service Department:
08000 869 769
who will
be able to how to send it for repair.
Laser Not Holding It’s
Charge
(LL300N, LL300S,
HV302, HV302G,
GL422N, Only)
Battery Issue
Check the battery pack. The battery pack may require charging
or need to be replaced due to age and/or a high number of
charging cycles.
Check the battery compartment for signs of damage and ensure
that the compartment is clean and that the battery terminals are
not corroded.
Detector Not Detect-
ing The Laser Beam
(All Laser Levels)
Multiple Causes
Check the batteries in the detector. They may be low and need
replacing.
Check the
Laser Level
is spinning and producing a visible laser
beam. You will be able to see the beam on your hands when
placed in front of the protective lighthouse.
Check the line of sight and ensure there is no obstructions.
Check that the laser level and detector are within the operat-
ing range. If you are too close to the laser it may not pickup the
beam. You need to be at least 3m away.
Check that the protective lighthouse glass is clean and free of
dust and dirt at all times.
Laser Will Not Power
Off
(All Laser Levels)
Poor Storage Conditions
If the Spectra Laser will not turn OFF, it is typically due to poor
storage (stored away wet, stored in a cold unheated building or
vehicle) etc. which has caused internal condensation to build up
and aff ect the main circuit board.
Safely dry the Laser and accessories out thoroughly and try
again. If this does not resolve the issue, please contact the Ser-
vice Department:
08000 869 769
who will be able to advise how
to sending it for repair.