2
2
Wall Mount Installation
2.1
Component Installation
The wall mount bracket and outdoor speed dome are shown in Figure 2-1.
Figure 2-1
2.2
Wall Mount Installation Steps
2.2.1
Installation Environments
The wall mount speed dome can be installed on a hard surface wall in indoor or outdoor
environments. Before the installation, please make sure:
The wall is thick enough to install the expansion bolt.
The wall can at least sustain the 8x weight of the speed dome, bracket and the
accessories.
2.2.2
Installation Steps
1)
Drill a hole of 50mm diameter for the cable exit in the installation wall.
2)
In Figure 2-2, connect the adapter block to the internal thread of the wall mount
bracket, until it reaches the end and then fix the set screw. Pull the intelligent
speed dome composite cable through the adapter block and pull it out of the other
end of the wall mount bracket. Line up the hook at the top of the external
enclosure to the inside hole of the adapter block and then push it to the end, and
then secure the three screws of the adapter block firmly.
Please note this step is
very important. Please make sure the screws are firm, to reduce the risk of the
camera falling
