Speco N64NR, User Manual, Page: 75 / 114

Alarm Management
NVR User Manual
9.4.8 Intrusion Detection
Intrusion Configuration :
Alarms will be triggered if someone or something intrudes into the pre-defined area.
1 Click Start

Settings

Camera

Smart Settings

Intrusion Detection to go to the following interface.
2 Select the camera, enable the intrusion detection.
3 Select the alarm area. Up to 4 alarm areas can be set up.
4 Draw the alarm area of the intrusion detection. Refer to the interface as shown below. Check “Draw Area” and
then click around the area where you want to set as the alarm area in the image (the alarm area should be a closed
area). Uncheck the “Draw Area” if you finish the drawing. Click the “Clear” to delete the alarm area.
5 Click “Apply” to save the settings.
6 Click “Processing Mode” to go to the alarm handling configuration interface of intrusion detection.
Intrusion Detection Alarm Handling Configuration :
1 Click Start  Settings  Alarm  Smart Event  Intrusion to go to the following interface.
2 Enable or disable “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”. The alarm
handling setting of intrusion detection alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for details).
3 Click “Apply” to save the settings. You can click “Intrusion Config” to go to the intrusion detection configuration
interface.
9.5 Exception Alarm
9.5.1 IPC Offline Settings
1 Click Start

Settings

Alarm

Exception

IPC Offline Settings to go to the interface as shown below.
68