Speco N64NR, User Manual, Page: 65 / 114

Alarm Management
NVR User Manual
9 Alarm Management
9.1 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each camera and then set up the
alarm handling of each camera.
1 Click Start  Settings  Alarm  Sensor Alarm to go to the following interface.
2 Select schedule and the alarm type (NO or NC) according to trigger type of the sensor.
3 Enable the sensor alarm of each camera.
4 Check the “Duration”, “Record”, “Snapshot”, “Push”, “Alarm-out” and “Preset” and enable or disable the “Buzzer”,
“Pop-up Video”, “Pop-up Message Box” and “E-mail” as required.
5 Click “Apply” to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Duration:
it refers to the interval time between the adjacent motion detections. For instance, if the duration time is
set to 10 seconds, once the system detects a motion, it will go to alarm and would not detect any other motion
(specific to camera) in 10 seconds. If there is another motion detected during this period, it will be considered as
continuous movement; otherwise it will be considered as a single motion.
Record
: check it and then the “Trigger Record” window will pop up automatically (you can also click “Configure”
button to pop up the window). Select camera on the left side and then click to set the camera as the trigger
camera. Select trigger camera on the right side and then click to cancel the trigger camera. Click “OK” button to
save the settings. The trigger cameras will record automatically when the sensor alarm is triggered.
Snapshot
: check it and then the “Trigger Snapshot” window will pop up automatically. Configure the trigger camera
in the window. The trigger cameras will snap automatically when the sensor alarm is triggered.
Push:
check it and choose ON or OFF. If it is ON, the system will send messages when the sensor alarm is triggered.
Alarm-out : check it and then the “Trigger Alarm-out” window will pop up automatically. Configure the trigger alarm-
out in the window. The system will trigger the alarm-out automatically when the sensor alarm is triggered. You need to
set the delay time and the schedule of the alarm outputs. See
9. 6 .1 Alarm-out for details.
Preset : check it and then the “Trigger Preset” window will pop up automatically. Configure the trigger preset of each
camera. To add presets, please see 6.2 Preset Setting for details.
Buzzer : if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the delay time of the
buzzer, please see 9. 6 .4 Buzzer for details.
Pop-up Video : After camera setting, the system will pop up the corresponding video automatically when the sensor
58