WIRELESS
WIRELESS NOTE
1
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1)This device may not cause harmful interference and (2) This device must
accept any interference received, including interference that may cause undesired
operation
Notice : The changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no
change to the antenna or the device is permitted. Any change to the antenna or the device
could result in the device exceeding the RF exposure requirements and void user’s
authority to operate the device.
1. Introduction
Thank you for purchasing Speco Technologies’ 128 Frequency-Selectable UHF Wireless
Microphone System. This wireless microphone system operates in UHF band frequency
with synthesizer controlled. The system with 128 selectable frequencies via Phase
Locked Loop (PLL) circuitry makes it easy to choose non-interfered channels. (The number
of frequency channels depends on local regulations.) Please read this instruction manual
carefully before operating the system. This manual covers the function and operation of
the wireless microphone system.
2. Safety
Do not spill liquid on the appliance and do not drop it on a hard concrete floor.
Do not place the appliance near heat sources such as radiators, amplifier, or etc. Do
not expose it to direct sunlight, extremely dust, excessive moisture, or vibration.
Take out the battery from transmitter, if the appliance will not be used for a long period
of time. This will avoid the damage resulting from a defective leaking battery
3. Environment
Do not throw used batteries into a fire or garbage bin with domestic rubbish. Be sure
to dispose of used batteries in accordance with local waste disposal rules.
When disposing the equipment, remove the batteries, separate the case, circuit
boards, and cables, and dispose of all components in accordance with local waste
disposal rules.
4. Wireless Note
Before setting up, make sure that the transmitter and receiver are tuned to the same
frequency.
Do not use two transmitters in the same frequency.
Use good quality batteries to avoid the damage resulting from a defective leaking
battery.
Turn the volume control on the receiver to adjust receiver output level to match input
level requirements of an audio mixer or amplifier.
While checking sound, move the transmitter around the area where you use the system
to look for dead spots. If you find any dead spot, change the receiver position. If it
does not work, avoid such places.
To avoid interference, do not put the receiver too near metal object and avoid
obstructions between transmitter and receiver.
Avoid the interference from TV, radio, other wireless appliances and etc.
Frequency/Channel Chart
WIRELESS
Summary of Contents for MWHH-UHF
Page 2: ......